Install the Engine Lifting Bracket

WARNING: This page is about a different variant/trim than selected.

Install the SST using part number 99794 1025 or an M10-1.25, length 25 mm {0.98 in} bolt as shown in the figure below.

Fig 1: Engine Lifting Bracket Bolt With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATIONS

Step	Part name
1	Engine lifting bracket	49 UN30 3050	-
2	BOLT	-	44.5 N.m {4.55 kgf.m, 32.8 ft.lb}