OBD Drive Mode (PYUL): Notes

WARNING: This page is about a different variant/trim than selected.

Using the OBD Drive Mode, the monitoring item requested by OBD regulations can be easily diagnosed.
Performing the Drive Mode inspects the OBD system for proper operation and must be performed to ensure that no additional DTCs are present.
The following modes are in the specific Drive Mode.
- Mode 03 (Variable Valve Timing, A/F Sensor, HO2S and TWC Repair Verification Drive Mode)

WARNING:

Observe legal speed limits when driving the vehicle and perform the procedure in a location where safety can be assured.
To prevent an accident, work with two people when the vehicle is being driven (one person drives vehicle, other person operates M-MDS).

NOTE:

Vehicle speed and engine speed detected by the PCM may differ from that indicated by the speedometer and tachometer. Use the M-MDS to monitor vehicle speed.
Disconnecting the battery will reset the memory. Do not disconnect the battery during and after Drive Mode.