LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (On-Board Diagnostic - Pcm (VIN A) (1 Of 4)) >> DTC P0134-00: A/F Sensor System: Inactive (PYUL) >> Details On DTCs

Details On DTCs

WARNING: This page is about a different variant/trim than selected.
P0134-00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location A/F sensor system: Inactive
Detection condition Determination conditions
  • The specified period of time has elapsed while the A/F sensor element impedance is the standard or more.
Preconditions
  • Battery voltage: 11-18 V *1
  • The following DTCs are not detected:
    • A/F sensor heater: P0031-00 and P0032-00
    • A/F sensor: P0131-00 and P0132-00

    *1: Standard can be verified by displaying PIDs using M-MDS

Malfunction determination period
  • 35 s period
Drive cycle
  • 2
Self test type
  • CMDTC self test
Sensor used
  • A/F sensor
Fail-safe
  • Fixes duty value of A/F sensor heater.
  • Stops fuel feedback control (A/F sensor) of fuel injection control.
  • Inhibits engine-stop by i-stop control.
Vehicle status when DTCs are output
  • Not applicable
Possible cause
  • A/F sensor malfunction
    • Malfunction in wiring harness (including connector/terminal) between A/F sensor and PCM
    • A/F sensor incorrect installation
    • A/F sensor deterioration
  • PCM connector or terminal malfunction
  • PCM malfunction