LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (On-Board Diagnostic - Pcm (VIN A) (1 Of 4)) >> DTC P0087-00: Fuel Pressure Sensor System: Circuit Malfunction (PYUL) >> Repeatability Verification Procedure

Repeatability Verification Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Warm up the engine to allow the engine coolant temperature to reach 80°C {176°F} or more.
  2. Start the engine and leave it idling for 1 min.
    NOTE:
    • The target calculated by the PCM is increased and the DTC P0087-00 determination conditions are met by repeating the Step 3 operation.
  3. Shift to 1st gear and accelerate/decelerate the vehicle to 30-50 km/h {19-31 mph}.
    NOTE:
    • Match the engine coolant temperature in the recorded freeze frame data/snapshot data, the vehicle speed, and engine speed values to the best extent possible while driving the vehicle.
  4. Try to reproduce the malfunction by driving the vehicle for 5 min based on the values in the freeze frame data/snapshot data.
scientia non olet · About LEMON Manuals