Details On DTCs
WARNING: This page is about a different variant/trim than selected.
P0087-00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Fuel pressure sensor system: Circuit malfunction |
| Detection condition |
Determination conditions |
- If any of the following conditions is met under condition A or condition B:
Condition A:
- The actual fuel pressure is the standard or more lower than the target fuel pressure while the fuel pressure feedback amount is maintained high.
Condition B:
- The PCM detects that the actual fuel pressure is standard or less continuously or intermittently.
|
| Preconditions |
|
| Malfunction determination period |
Condition A: Condition B:
|
| Drive cycle |
|
| Self test type |
|
| Sensor used |
|
| Fail-safe |
- Limits intake air amount
- Stops high pressure fuel pump control
- Inhibits engine-stop by i-stop control.
|
| Vehicle status when DTCs are output |
|
| Possible cause |
- Air suction in fuel line due to fuel is runout
- High pressure fuel pump connector or terminal malfunction
- Fuel pressure sensor connector or terminal malfunction
- PCM connector or terminal malfunction
- Fuel pressure sensor malfunction
- Fuel delivery system malfunction (insufficient fuel pressure)
- Fuel injector malfunction
- High pressure fuel pump malfunction
- Relief valve (built-into high pressure fuel pump) malfunction
- PCM malfunction
|