Details On DTCs

WARNING: This page is about a different variant/trim than selected.

P0014-00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Hydraulic variable valve timing control system: over-advanced
Detection condition	Determination conditions	For the advance amount from the maximum exhaust valve retard position, a condition in which the actual advance amount is larger than the target value continues for a specified period of time.
	Preconditions	Engine oil temperature: 20°C {68°F} or more 1 Hydraulic variable valve timing control: feedback mode The following DTCs are not detected: P0335-00 and P0365-00 1: Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	5 s period
	Drive cycle	2
	Self test type	CMDTC self test
	Sensor used	CKP sensor Exhaust CMP sensor
Fail-safe	Inhibits engine-stop by i-stop control.
Vehicle status when DTCs are output	Not applicable
Possible cause	Oil control valve (OCV) malfunction Spool valve in oil control valve (OCV) is stuck in advanced position Low engine oil level Hydraulic variable valve timing actuator malfunction Timing chain malfunction Poor assembly Looseness or jumping Mis-detection of exhaust CMP sensor Engine oil malfunction Use of unspecified engine oil Low engine oil pressure Engine oil runners are clogged or have leakage PCM malfunction