Details On DTCs

WARNING: This page is about a different variant/trim than selected.

B10A2-00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Vehicle collision determination system: Vehicle collision
Detection condition	Determination conditions	The PCM detects a vehicle collision based on the collision signal received from the SAS control module.
	Preconditions	Not applicable
	Drive cycle	1
	Self test type	CMDTC self test
	Sensor used	PCM
Fail-safe	Stops fuel injection control Stops fuel pump control Stops ignition control Stops engine coolant fan control Inhibits engine-stop by i-stop control.
Vehicle status when DTCs are output	Stops fuel pump operation when ignition is switched ON Delays starter operation during cranking for maximum 1.2 s.
Possible cause	Vehicle is involved in collision (collision signal from Sophisticated Airbag Sensor (SAS) control module is received) SAS control module malfunction PCM malfunction