Engine Does Not Restart [PYUL]: Outline
WARNING: This page is about a different variant/trim than selected.
ENGINE DOES NOT RESTART (PYUL) DESCRIPTION AND POSSIBLE CAUSE
| Description |
- The engine does not restart after the engine was stopped by the i-stop control.
|
| Possible cause |
- DTCs are stored in the following modules.
- PCM
- TCM
- Electronically controlled brake unit/DSC HU/CM
- Dash-electrical supply unit
- Body control module (BCM)
- Engine does not crank when engine restart is initiated.
- Engine starting system malfunction
- i-stop (engine stop control) permit conditions are not met due to either of the following causes:
- Driver operation
- Environment (problem other than with vehicle)
- i-stop related parts malfunction
NOTE:
- PIDs related to i-stop can be displayed in a list using the M-MDS data monitor diagnostic function.
- If the engine is stopped by the i-stop control while the following data monitor items on the M-MDS are being viewed, the data monitor items may no longer be displayed.
- ACC_LON_C
- BRK_FLD_PRES
- BRK_PEDAL_SW
- WSPD_SEN_L/F
- WSPD_SEN_L/R
- WSPD_SEN_R/F
- WSPD_SEN_R/R
|
| System wiring diagram |
|