LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Symptom Troubleshooting - I-Stop (VIN A)) >> Acceleration Malfunction [PYUL] >> Outline

Acceleration Malfunction [PYUL]: Outline

WARNING: This page is about a different variant/trim than selected.
ACCELERATION MALFUNCTION (PYUL) DESCRIPTION AND POSSIBLE CAUSE

Description
  • Acceleration from i-stop is not smooth.
  • Suppresses (shock) when accelerating vehicle from i-stop.
  • Engine vibration increases when engine is restarted.
Possible cause
NOTE:
  • MT vehicles are not included because the driver releases the brake pedal and depresses the clutch pedal to accelerate.
Hill launch assist function system (DSC) malfunction 
  • False detection of inclination angle (cannot calculate correct road slope)
    • Low-G sensor (built-into SAS control module) malfunction (In this case, the SAS control module records DTCs C0061:29 and C0062:29).
    • Low-G sensor (built-into SAS control module) initialization malfunction (In this case, the SAS control module records DTC U2100:00).
  • False detection of brake fluid pressure
    • Brake fluid pressure sensor (built into electronically controlled brake unit/DSC HU/CM) malfunction
  • Cannot maintain brake fluid pressure
    • Electronically controlled brake unit/DSC HU/CM malfunction
AT system malfunction 
  • Electric AT oil pump malfunction (operation malfunction, insufficient pressure)
    • Electric at oil pump relay malfunction (stuck open)
    • Malfunction in wiring harness (including connector/terminal) between battery and electric AT oil pump relay
    • Malfunction in wiring harness (including connector/terminal) between electric At oil pump and body ground
    • Malfunction in wiring harness (including connector/terminal) between electric AT oil pump relay and electric AT oil pump
    • AT main relay malfunction
    • Malfunction in wiring harness (including connector/terminal) between battery and AT main relay
    • Malfunction in wiring harness (including connector/terminal) between AT main relay and TCM
    • Malfunction in wiring harness (including connector/terminal) between TCM and electric at oil pump
    • Electric AT oil pump malfunction
    • TCM malfunction
  • AT malfunction
G16690382Courtesy of MAZDA MOTORS CORP.
1 Battery
2 AT main relay
3 Electric AT oil pump relay
4 Electric At oil pump
5 TCM