Details On DTCs

WARNING: This page is about a different variant/trim than selected.

P2251: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	A/F sensor system: Open circuit in A/F sensor signal circuit
Detection condition	Determination conditions	The following conditions are met: A/F sensor element impedance is specified value or more The voltage (Vs+ terminal) of the A/F sensor signal circuit is less than the standard, or unstable.
	Preconditions	Battery voltage: 11-18 V 1 A/F sensor is activated. The following DTCs are not detected: A/F sensor terminal F voltage (Vs+ terminal) is less than the standard: A/F sensor heater: P0031: 00 and P0032: 00 A/F sensor terminal F voltage (Vs+ terminal) is unstable: Internal PCM malfunction: P064D: 00 1: Standard can be verified by displaying PIDs using M-MDS
	Malfunction determination period	Not applicable
	Drive cycle	2
	Self test type	CMDTC self test, KOER self test
	Sensor used	A/F sensor
Fail-safe	Inhibits engine-stop by i-stop control.
Vehicle status when DTCs are output	Not applicable
Possible cause	Malfunction in wiring harness (including connector/terminal) between A/F sensor and PCM A/F sensor malfunction PCM malfunction