DTC P2107-00: Throttle Valve Actuator Control System: Processor Error
WARNING: This page is about a different variant/trim than selected.
P2107: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Throttle valve actuator control system: Processor error |
| Detection condition |
|
| Fail-safe |
- Restricts the upper limit of the engine speed.
- Fixes the throttle valve opening angle.
- Inhibits engine-stop by i-stop control.
|
| Possible cause |
- Malfunction in wiring harness (including connector/terminal) between throttle body and PCM (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- PCM malfunction
- Throttle valve actuator control driver internal processor error (built-into PCM) (Refer to [PCM REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
PCM |
| 2 |
Throttle body |