Intention of troubleshooting procedure

WARNING: This page is about a different variant/trim than selected.

Step 1
- Allow the vehicle to cool down for while.
Step 2
- Perform an inspection of the transfer.
Step 3
- Perform an inspection of the front differential.
Step 4
- Perform an inspection of the coupling compartment and the rear differential.
Repair completion verification
- Verify that the primary malfunction is resolved and there are no other malfunctions.

P182F: 00 (PCM (PYUL)) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: ALLOW THE VEHICLE TO COOL DOWN FOR WHILE Switch the main power OFF and allow vehicle to cool down.	-	Go to the next step.
2	PURPOSE: CHECK FOR TRANSFER FAILURE Inspect the applicable part. (Refer to [MAGNETIC CLUTCH INSPECTION ] in service information). Is the part normal?	Yes	Go to the next step.
2		No	Replace the transfer and perform the repair completion verification 1. (Refer to [TRANSFER REMOVAL/INSTALLATION ] in service information).
3	PURPOSE: INSPECT FRONT DIFFERENTIAL FOR MALFUNCTION Shift the selector lever to N position. Lift up the vehicle. Turn the front propeller shaft and rotate the front wheels. Do the front wheels rotate smoothly?	Yes	Go to the next step.
3		No	Replace the front differential and perform the repair completion verification 1. (Refer to [FRONT DIFFERENTIAL REMOVAL/INSTALLATION [AWD] ] in service information).
4	PURPOSE: INSPECT COUPLING COMPARTMENT AND REAR DIFFERENTIAL FOR MALFUNCTION Shift the selector lever to N position. Display simulation item [CUP_SOL] using the M-MDS. (See SIMULATION INSPECTION .) Lift up the vehicle. Turn simulation item [CUP_SOL] on to turn AWD solenoid on. Turn the rear propeller shaft and rotate the rear wheels. Do the rear wheels rotate smoothly?	Yes	Go to the next step.
4		No	Replace the rear differential and perform the repair completion verification 1. (Refer to [ COUPLING COMPARTMENT REMOVAL/INSTALLATION] in service information). (Refer to [REAR DIFFERENTIAL REMOVAL/INSTALLATION ] in service information).
Repair completion verification 1	PURPOSE: VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Clear the DTC recorded in the memory. (See CLEARING DTC .) Replicate the vehicle conditions at the time the DTC was detected using the following procedure. Implement the repeatability verification procedure. (See Repeatability Verification Procedure ). Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction recurs, replace the PCM, then go to the next step. (Refer to [PCM REMOVAL/INSTALLATION ] in service information).
Repair completion verification 1		No	Go to the next step.
Repair completion verification 2	PURPOSE: VERIFY IF OTHER DTCs DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification 2		No	DTC troubleshooting completed.