DTC P16C2-00: Pcm Processing Device

WARNING: This page is about a different variant/trim than selected.

P16C2: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	PCM processing device
Detection condition	Any of the following conditions is met. The PCM detects a processing error in the signal input to the PCM from the CKP sensor. The PCM detects a processing error in the signal input to the PCM from the intake CMP sensor.
Fail-safe	Not applicable
Possible cause	PCM connector or terminal malfunction (See CONNECTOR INSPECTION .) PCM malfunction PCM internal CPU malfunction (Refer to [PCM REMOVAL/INSTALLATION ] in service information).
Repeatability verification procedure	Clear the DTC recorded in the memory. (See CLEARING DTC .) Perform the KOEO or KOER self test. (See DTC INSPECTION .)
System Wiring Diagram	Not applicable