DTC P164D-00: Pcm Configuration

WARNING: This page is about a different variant/trim than selected.

P164D: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	PCM configuration
Detection condition	The electronic control coupling characteristic value is not registered correctly in the PCM.
Fail-safe	Inhibits the i-ACTIV AWD system control.
Possible cause	The electronic control coupling value is not input to the PCM correctly. (See COUPLING COMPONENT CALIBRATION DATA WRITING.) PCM malfunction (Refer to [PCM REMOVAL/INSTALLATION ] in service information).
Repeatability verification procedure	Clear the DTC recorded in the memory. (See CLEARING DTC .) Switch the ignition ON (engine off).
System Wiring Diagram	Not applicable