Intention of troubleshooting procedure
WARNING: This page is about a different variant/trim than selected.
- Step 1
- Verify if deposit cleaner has been added lately.
- Step 2
- Step 3
P1200: 00 (PCM (PYUL)) DIAGNOSTIC PROCEDURE
| Step |
Inspection |
Results |
Action |
| 1 |
PURPOSE: VERIFY IF DEPOSIT CLEANER HAS BEEN ADDED LATELY
- Ask the customer if deposit cleaner has been added lately.
- Has deposit cleaner been added lately?
|
Yes |
DTC troubleshooting completed. |
| No |
Go to the next step. |
| 2 |
PURPOSE: REFILL THE FUEL
|
- |
Go to the next step. |
| 3 |
PURPOSE: ADD DEPOSIT CLEANER
- Add deposit cleaner.
NOTE:
- To maintain the effect of deposit cleaner, strongly advise the customer to not add fuel until the fuel tank is near empty.
- To maintain the effect of deposit cleaner, if deposit cleaner has been added lately and then more fuel has not been added, it is not necessary to recharge deposit cleaner.
|
- |
DTC troubleshooting completed.
NOTE:
- DTC P1200: 00 is stored again until the deposit cleaner takes effect and the deposit is removed even though the DTC is cleared. The DTC is cleared automatically after the deposit cleaner takes effect and the deposit is removed.
- Because the traveled distance is reset if the PCM is replaced, the PCM cannot determine DTC P1200: 00 until the vehicle is driven 2, 400 km {1, 491 miles} or more which is the precondition for the DTC.
|