Function Inspection Using M-MDS
WARNING: This page is about a different variant/trim than selected.
P0A8F: 00 (PCM (PYUL)) DIAGNOSTIC PROCEDURE
| Step | Inspection | Results | Action |
|---|---|---|---|
| 1 | PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
|
- | Go to the next step. |
| 2 | PURPOSE: VERIFY IF BATTERY VOLTAGE IS FALSELY RECOGNIZED BY DTC RELATED CURRENT SENSOR
|
Yes | Repair or replace the malfunctioning location according to the applicable DTC troubleshooting. (See P058A-00: (PYUL) ). Go to the next step. |
| No | Go to the next step. | ||
| 3 | PURPOSE: VERIFY IF BATTERY VOLTAGE IS FALSELY RECOGNIZED BY DTC RELATED CAN OR LIN COMMUNICATION
|
Yes | Repair or replace the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (PYUL)] .) Go to the next step. |
| No | Go to the next step. | ||
| 4 | PURPOSE: VERIFY DTC
|
Yes | Replace the battery. (Refer to [BATTERY REMOVAL/INSTALLATION
] in service information). Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification 1. |
| No | Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1. |