DTC P061B-00: Pcm Processor Error
WARNING: This page is about a different variant/trim than selected.
P061B: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
PCM processor error |
| Detection condition |
- PCM internal malfunction
- There is a malfunction in the sensor input signal to the PCM.
- There is a malfunction between the PCM and the sensor that inputs a signal to the PCM.
|
| Fail-safe |
- Engine output is restricted.
- Fixes the throttle valve opening angle.
- Inhibits engine-stop by i-stop control.
|
| Possible cause |
- DTCs are stored in the PCM. (Error in signal input to PCM by sensor) (See DTC TABLE [PCM (PYUL)]
.)
- PCM connector or terminal malfunction (See CONNECTOR INSPECTION
.)
- PCM malfunction (Refer to [PCM REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
| System Wiring Diagram |
|