DTC P05C0-00: Active Air Shutter System: Actuator Temperature Abnormality
WARNING: This page is about a different variant/trim than selected.
P05C0: 00 (PCM (PYUL)) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Active air shutter system: Actuator temperature abnormality |
| Detection condition |
- Internal temperature of active air shutter actuator is standard or more
|
| Fail-safe |
- Stops active air shutter control
- Inhibits engine-stop by i-stop control.
|
| Possible cause |
- DTCs are stored in the PCM. (U0284: 00) (See U0284-00: (PYUL)
.)
- Overheat
- Active air shutter malfunction (Refer to [ACTIVE AIR SHUTTER INSPECTION
] in service information).
- PCM malfunction (Refer to [PCM REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Replicate the vehicle conditions at the time the DTC was detected using the following procedure.
- Start the engine.
WARNING:
- Observe legal speed limits when driving the vehicle and perform the procedure in a location where safety can be assured.
- To prevent an accident, work with two people when the vehicle is being driven (one person drives vehicle, other person operates M-MDS).
- Drive the vehicle at 10 km/h {6.2 mph} or more for approx. 1 min.
|
| System Wiring Diagram |
|