LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (VIN A)) >> Oil Pump Removal/Installation [PYUL] >> Remove Engine Mount (LH) >> Engine mount (LH) removal note

Engine mount (LH) removal note

WARNING: This page is about a different variant/trim than selected.
  1. Tighten the engine mount (LH) stud bolt.
    • Tighten the stud bolt because it may have loosened.
    Fig 1: Engine Mount (LH) Stud Bolt With Torque Specification
    G16700437Courtesy of MAZDA MOTORS CORP.
    TIGHTENING TORQUE SPECIFICATION

    Symbol Content
    34 N.m {3.45 kgf.m, 25.1 ft.lb}
  2. Remove the SST using the procedure shown in the figure below.
    G16691742Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    49 JP01 1A0
  3. Remove the engine mount (LH).
scientia non olet · About LEMON Manuals