Remove Front Propeller Shaft (AWD)
WARNING: This page is about a different variant/trim than selected.
- Remove using the procedure shown in the figure below.
Courtesy of MAZDA MOTORS CORP. TIGHTENING TORQUE SPECIFICATION
| Step |
Part name |
 |
| 1 |
Bolt |
91 N.m {9.25 kgf.m, 67.05 ft.lb} |
| 2 |
Transverse member |
- |
| 3 |
Bolt |
8.5 N.m {84 kgf.cm, 73 in.lbf} |
| 4 |
Bolt |
26 N.m {2.65 kgf.m, 19.2 ft.lb} |
| 5 |
Front propeller shaft |
- |