Nut installation note
WARNING: This page is about a different variant/trim than selected.
- Tighten the engine mount (LH) stud bolt.
- Tighten the stud bolt because it may have loosened.
TIGHTENING TORQUE SPECIFICATIONSymbol Content 34 N.m {3.45 kgf.m, 25.1 ft.lb} - Install the nuts using the procedure shown in the figure below.
- If the alignment marks have deviated, align them by slightly moving the engine.
Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATIONSymbol Content (1) (2)... Servicing procedure Temporarily tighten 98 N.m {10 kgf.m, 72.45 ft.lb}