LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (VIN A)) >> Oil Cooler Removal/Installation [PYUL] >> Remove Oil Cooler >> Bolt installation note

Bolt installation note

WARNING: This page is about a different variant/trim than selected.
  1. Install the bolts in the order shown in the figure below.
Fig 1: Oil Cooler Bolts Tightening Sequence With Torque Specification
G16691428Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATION

Symbol Content
(1) (2)... Servicing procedure
Temporarily tighten
10 N.m {102 kgf.cm, 89 in.lbf}
scientia non olet · About LEMON Manuals