LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (VIN A)) >> Engine Oil Solenoid Valve Removal/Installation [PYUL] >> Remove Front Under Cover No. 2

Remove Front Under Cover No. 2

WARNING: This page is about a different variant/trim than selected.
  1. Remove using the procedure shown in the figure below.
Fig 1: Front Under Cover No. 2, Fasteners And Bolts With Torque Specification
G16691187Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATION

Step Part name
1 Bolt 11 N.m {110 kgf.cm, 95 in.lbf}
2 Fastener -
3 Front under cover No. 2 -
scientia non olet · About LEMON Manuals