LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (VIN A)) >> Engine Oil Replacement [PYUL] >> Drain Engine Oil

Drain Engine Oil

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Hot engines and engine oil can cause severe burns. Turn off the engine and wait until it and the engine oil have cooled.
  • A vehicle that is lifted but not securely supported on safety stands is dangerous. It can slip or fall, causing death or serious injury. Never work around or under a lifted vehicle if it is not securely supported on safety stands.
  • Continuous exposure to USED engine oil has caused skin cancer in laboratory mice. Protect your skin by washing with soap and water immediately after working with engine oil.
CAUTION:
  • If engine oil is spilled on the exhaust system, wipe it off completely. If you fail to wipe the spilled engine oil, it will produce fumes because of the heat.
  1. Position the vehicle on level ground.
  2. Warm up the engine to allow the engine oil temperature to reach 60°C {140°F} or more.
  3. Stop the engine and wait for 5 min or more.
  4. Remove the oil filler cap.
  5. Remove in the order indicated in the table.
    G16691142Courtesy of MAZDA MOTORS CORP.
    PART NAME DESCRIPTION

    Step Part name
    1 Oil pan drain plug -
    2 Gasket Replacement part
  6. Drain the engine oil into a container.
  7. Wait until the engine oil starts to drip.
  8. Install in the order indicated in the table.
Fig 1: Oil Pan Drain Plug And Gasket With Torque Specification
G16691143Courtesy of MAZDA MOTORS CORP.
TIGHTENING TORQUE SPECIFICATION

Step Part name
1 Gasket Replacement part -
2 Oil pan drain plug - 35.5 N.m
scientia non olet · About LEMON Manuals