Simultaneously Aim Radar Sensor (Front) And (Front Side) (With Radar Sensor (Front Side)

CAUTION:

• When repainting the front bumper face, do not repaint the radar emitting area shown in the figure below (same as right side) because the radar sensor (front side) aiming may not be performed correctly.

Courtesy of MAZDA MOTORS CORP.

SYMBOL AND CONTENT DESCRIPTION

Symbol	Content
	Radar emitting area
	118 mm {4.65 in}
	220 mm {8.66 in}
	55 mm {2.2 in}
	35 mm {1.4 in}
	157 mm {6.18 in}
	100 mm {3.94 in}

NOTE:

• Refer to the troubleshooting service information for the procedure for using the M-MDS. (Refer to FRONT AND FRONT SIDE RADAR SENSOR SIMULTANEOUS AIMING in the troubleshooting service information).