LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical (VIN A) (6 Of 6)) >> Timing Chain Removal/Installation [PYUL] >> Remove Engine Mount (LH) >> Nut installation note

Nut installation note

WARNING: This page is about a different variant/trim than selected.
  1. Tighten the engine mount (LH) stud bolt.
    • Tighten the stud bolt because it may have loosened.
    Fig 1: Engine Mount Stud Bolt With Torque Specifications
    G16700437Courtesy of MAZDA MOTORS CORP.
    TIGHTENING TORQUE SPECIFICATIONS

    Symbol Content
    34 N.m {3.45 kgf.m, 25.1 ft.lb}
  2. Install the nuts using the procedure shown in the figure below.
    • If the alignment marks have deviated, align them by slightly moving the engine.
G16701938Courtesy of MAZDA MOTORS CORP.
SYMBOL AND CONTENT DESCRIPTION

Symbol Content
(1) (2)... Servicing procedure
Temporarily tighten
98 N.m {10 kgf.m, 72.45 ft.lb}
scientia non olet · About LEMON Manuals