LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-90 Turbo Select >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical (VIN A) (6 Of 6)) >> Timing Chain Removal/Installation [PYUL] >> Remove Engine Mount (LH) >> Bolt removal note

Bolt removal note

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When supporting the engine, perform the following procedure to prevent oil pan deformation.
    • When using an engine lifter: Place an appropriate rubber strip (approx. 20 mm {0.79 in} thick) between the engine lifter and the oil pan to support the oil pan.
    • When using a garage jack: Place an appropriate rubber strip (approx. 20 mm {0.79 in} thick) on a wooden board that is large enough to cover the oil pan to support the oil pan.
  1. Support the engine (oil pan) using a commercially available engine lifter or garage jack.
    G16701932Courtesy of MAZDA MOTORS CORP.
    SYMBOL AND CONTENT DESCRIPTION

    Symbol Content
    1 Oil pan
    2 Rubber
    3 Engine lifter
    Approx. 20 mm {0.79 in}
  2. Remove the bolt.
scientia non olet · About LEMON Manuals