Simultaneously Aim Radar Sensor (Front) And (Front Side) (With Radar Sensor (Front Side))
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- When repainting the front bumper face, do not repaint the radar emitting area shown in the figure below (same as right side) because the radar sensor (front side) aiming may not be performed correctly.
SYMBOL AND CONTENT DESCRIPTION
| Symbol | Content |
|---|---|
| Radar emitting area | |
| 118 mm {4.65 in} | |
| 220 mm {8.66 in} | |
| 55 mm {2.2 in} | |
| 35 mm {1.4 in} | |
| 157 mm {6.18 in} | |
| 100 mm {3.94 in} |
NOTE:
- Refer to the Troubleshooting Service Information for the procedure for using the M-MDS. (Refer to RADAR SENSOR (FRONT) AND (FRONT SIDE) SIMULTANEOUS AIMING in the appropriate troubleshooting information).