Brake override system operation inspection

WARNING: This page is about a different variant/trim than selected.

NOTE:

If the brake override system operates normally after performing the following inspection, the PCM detects DTC P2299:00.

Start the engine and let it idle.
Verify that the engine speed becomes less than 1, 200 rpm under the following conditions.

N position
Engine speed of 3, 000 rpm or more with accelerator pedal depressed
Brake pedal depressed
- If the engine speed becomes approx. 1, 200 rpm, clear the PCM DTC using the M-MDS. (System operation is normal).
- If the engine speed does not become approx. 1, 200 rpm, inspect for the following parts, then repair or replace the malfunctioning part:
  - APP sensor (Refer to [ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION ] in Service Information).
  - Brake switch (Refer to [BRAKE SWITCH INSPECTION ] in Service Information).
  - Communication between PCM and TCM (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .)