A Message Is Displayed From Center Display Indicating That Daily Oil Quantity Check (Idle Check) Cannot Be Manually Performed Or That There Is An Error [PYUL]: Outline

WARNING: This page is about a different variant/trim than selected.

A MESSAGE IS DISPLAYED FROM CENTER DISPLAY INDICATING THAT DAILY OIL QUANTITY CHECK CANNOT BE MANUALLY PERFORMED DESCRIPTION AND POSSIBLE CAUSE

Troubleshooting item	A message is displayed from center display indicating that daily oil quantity check (idle check) cannot be manually performed or that there is an error
Description	The [Start measurement] button of [Daily check of oil quantity (idle check)] on the center display screen does not become operable. An error message is displayed on the center display after starting the daily oil quantity check (idle check).
Possible cause	Due to customer's driving operation or vehicle conditions: Since one of the following vehicle conditions is not satisfied, the [Start measurement] button of [Daily oil quantity check (idle check)] on the center display screen does not become operable. Switch the ignition ON (engine on) Selector lever: P position Electric parking brake operation Ramp condition: Longitudinal G: 0.05 G or less (tilt angle: 3.1 degrees or less) G on the left and right side of the vehicle: 0.05 g or less (inclination angle: 3.1 degrees or less) One of the following engine conditions is not satisfied. Engine oil temperature: 20-100°C {68-212°F} Vehicle stopped (vehicle speed: 0 km/h {0 mph} or less) Engine rotation speed: 500-3, 000 rpm If the part is defective: Malfunction in CAN communication line between engine oil level sensor and PCM Engine oil level sensor malfunction Engine oil pressure sensor malfunction Engine oil temperature sensor malfunction ABS wheel-speed sensor malfunction Low-G sensor malfunction Connectivity master unit (CMU) malfunction Body control module (BCM) malfunction Malfunction in CAN communication line between PCM and body control module (BCM) PCM malfunction
System wiring diagram	Not applicable

Troubleshooting item

A message is displayed from center display indicating that daily oil quantity check (idle check) cannot be manually performed or that there is an error

Description

The [Start measurement] button of [Daily check of oil quantity (idle check)] on the center display screen does not become operable.
An error message is displayed on the center display after starting the daily oil quantity check (idle check).

Possible cause

Due to customer's driving operation or vehicle conditions:

Since one of the following vehicle conditions is not satisfied, the [Start measurement] button of [Daily oil quantity check (idle check)] on the center display screen does not become operable.

Switch the ignition ON (engine on)
Selector lever: P position
Electric parking brake operation
Ramp condition:
- Longitudinal G: 0.05 G or less (tilt angle: 3.1 degrees or less)
- G on the left and right side of the vehicle: 0.05 g or less (inclination angle: 3.1 degrees or less)
- One of the following engine conditions is not satisfied.
Engine oil temperature: 20-100°C {68-212°F}
Vehicle stopped (vehicle speed: 0 km/h {0 mph} or less)
Engine rotation speed: 500-3, 000 rpm

If the part is defective:

Malfunction in CAN communication line between engine oil level sensor and PCM
Engine oil level sensor malfunction
Engine oil pressure sensor malfunction
Engine oil temperature sensor malfunction
ABS wheel-speed sensor malfunction
Low-G sensor malfunction
Connectivity master unit (CMU) malfunction
Body control module (BCM) malfunction
Malfunction in CAN communication line between PCM and body control module (BCM)
PCM malfunction

System wiring diagram

Not applicable