Function Inspection Using M-MDS

P2463: 00 (PCM (H3T)) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: VERIFY RELATED REPAIR INFORMATION OR SERVICE INFORMATION AVAILABILITY Verify related Service Bulletins, on-line repair information, or Service Information availability. Is any related Information available?	Yes	Perform repair or diagnosis according to the available information. If the vehicle is not repaired, go to the next step.
1		No	Go to the next step.
2	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the freeze frame data/snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
3	PURPOSE: INSPECT FOR OTHER RELATED DTCs Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Are any of the following DTCs displayed? P24A4: 00	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See P24A4-00: (H3T) ). NOTE: When the diagnostic procedure for DTC P24A4: 00 is completed, the diagnostic procedure for DTC P2463: 00 is also completed.
3		No	Go to the next step.
4	PURPOSE: INSPECT FOR OTHER RELATED DTCs Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Has any DTC other than P2463: 00 been stored?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [PCM (H3T)] .) NOTE: When a DTC other than DTC P2463: 00 is stored, compulsory GPF regeneration may be restricted by the PCM control. Perform the compulsory GPF regeneration. (See COMPULSORY REGENERATING GPF [H3T].) Go to the troubleshooting diagnostic procedure and perform the repair completion verification 1.
4		No	Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.