Troubleshooting Diagnostic Procedure

P182F: 00 (PCM (H3T)) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION Record the snapshot data. NOTE: Recording can be facilitated using the screen capture function of the PC.	-	Go to the next step.
2	PURPOSE: ALLOW VEHICLE TO COOL DOWN FOR WHILE Switch the ignition off and allow vehicle to cool down.	-	Go to the next step.
3	PURPOSE: INSPECT TRANSFER FOR EFFECT MALFUNCTION Shift the selector lever to N position. Lift up the vehicle. Turn the propeller shaft and rotate the front wheels. Do the front wheels rotate smoothly?	Yes	Go to the next step.
3		No	Replace the transfer and perform the repair completion verification 1. (Refer to [TRANSFER REMOVAL/INSTALLATION ] in service information).
4	PURPOSE: INSPECT ELECTRONIC CONTROL COUPLING AND REAR DIFFERENTIAL FOR MALFUNCTION Shift the selector lever to N position. Access the simulation item [CUP_SOL] using the M-MDS. (See SIMULATION INSPECTION .) Lift up the vehicle. Turn the simulation item [CUP_SOL] on and turn the AWD solenoid on. Turn the propeller shaft and rotate the rear wheels. Do the rear wheels rotate smoothly?	Yes	Go to the next step.
4		No	Repair or replace the malfunctioning location and perform the repair completion verification 1. (Refer to [ ELECTRONIC CONTROL COUPLING REMOVAL/INSTALLATION] in service information). (Refer to [REAR DIFFERENTIAL REMOVAL/INSTALLATION ] in service information).
Repair completion verification 1	PURPOSE: VERIFY THAT VEHICLE IS REPAIRED Install/connect the part removed/disconnected during the troubleshooting procedure. Clear the DTC recorded in the memory. (See CLEARING DTC .) Perform the DTC inspection for the PCM. (See DTC INSPECTION .) Is the same Pending DTC present?	Yes	Refer to the controller area network (CAN) malfunction diagnosis flow to inspect for a CAN communication error. (See MALFUNCTION DIAGNOSIS FLOW [CONTROLLER AREA NETWORK (CAN)] .) If the CAN communication is normal, perform the diagnosis from Step 1. If the malfunction recurs, replace the PCM, then go to the next step. (Refer to [PCM REMOVAL/INSTALLATION ] in service information).
Repair completion verification 1		No	Go to the next step.
Repair completion verification 2	PURPOSE: VERIFY IF OTHER DTCs DISPLAYED Perform the DTC inspection. (See DTC INSPECTION .) Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning location according to the applicable DTC troubleshooting.
Repair completion verification 2		No	DTC troubleshooting completed.