Repeatability Verification Procedure
WARNING:
- To prevent an accident, work with another person when the vehicle is being driven (one person drives vehicle, other person operates M-MDS).
- Observe legal speed limits when driving the vehicle and perform the procedure in a location where safety can be assured.
- Access the following PIDs using the M-MDS. (See PID/DATA MONITOR INSPECTION
.)
- BOOST_PRES_DSD
- MAP
- Start the engine and warm it up completely.
- Shift to 2nd gear and rapidly accelerate the vehicle to 40 km/h {25 mph}.
- Accelerate in 2nd gear from 40 km/h {25 mph} to 55 km/h {35 mph} for 5 s or more.
- Verify that the difference between BOOST_PRES_DSD and MAP during acceleration is less than 70 kPa {0.71 kgf/cm2 , 10 psi}.