Inspection/action procedure

Proceed with the inspection/action in the order from Step 1 below. * After part repair or replacement, perform the repeatability verification procedure and perform a DTC inspection. (See DTC INSPECTION .)

- If the same DTC is displayed again as a result of the DTC inspection, go to the next step.

1. Inspect the wiring harness (including connector/terminal) between the low fuel pressure sensor/fuel temperature sensor and the PCM.

   Purpose/reason (possiblecause)	Malfunction in wiring harness (including connector/terminal) between low fuel pressure sensor/fuel temperature sensor and PCM
   Referred to Service Information(s) item	See CIRCUIT INSPECTION ; See CONNECTOR INSPECTION

2. Inspect the fuel temperature sensor.

   Purpose/reason (possible cause)	Fuel temperature sensor malfunction
   Referred to Service Information(s) item	See FUEL TEMPERATURE SENSOR INSPECTION (VIN C AND VIN D)

3. Replace the PCM.

   Purpose/reason (possible cause)	PCM malfunction (no other possible malfunction considered)
   Referred to Service Information(s) item	See PCM REMOVAL/INSTALLATION (VIN C AND VIN D) .