Manifold Absolute Pressure (MAP) Sensor/Intake Air Temperature (IAT) Sensor No. 2 Removal/Installation

Open the capsule cover. (See CAPSULE COVER OPEN/CLOSE [H3T] .)
Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the water-cooled charge air cooler reserve tank with the water hose still connected and secure it using wire or rope so that it is out of the way. (See WATER-COOLED CHARGE AIR COOLER RESERVE TANK REMOVAL/INSTALLATION [H3T] .)

Remove in the order indicated in the table.

Fig 1: MAP Sensor/IAT Sensor No. 2 Bolt With Torque Specifications

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATIONS

Step	Part name
1	Connector	-
2	Bolt	9.5 N.m {97 kgf.cm, 84 in.lbf}
3	Remove the MAP sensor/IAT sensor No. 2	-