| 2_WAY_VLV |
OFF/ON |
Expansion valve with solenoid valve (A/C unit side)/expansion valve with solenoid valve (front A/C unit side) operation status |
| 2_AY_VLV_R |
OFF/ON |
Expansion valve with solenoid valve (rear A/C unit side) operation status |
| AIR_MIX_MODE_L |
Stopped/AirMix LH Actuator Max Cold Position/AirMix LH Actuator Max Hot Position/AirMix LH Actuator Half Position |
- Stopped: Air mix actuator (LH) is stopped
- AirMix LH Actuator Max Cold Position: Air mix actuator (LH) is operating so that air mix door position is at MAX COLD control
- AirMix LH Actuator Max Hot Position: Air mix actuator (LH) is operating so that air mix door position is at MAX HOT control
- AirMix LH Actuator Half Position: Air mix actuator (LH) is operating so that air mix door position is at middle position of MAX COLD control and MAX HOT control
|
| AIR_MIX_MODE_R |
Stopped/AirMix RH Actuator Max Cold Position/AirMix RH Actuator Max Hot Position/AirMix RH Actuator Half Position |
- Stopped: Air mix actuator (RH) is stopped
- AirMix RH Actuator Max Cold Position: Air mix actuator (RH) is operating so that air mix door position is at MAX COLD control
- AirMix RH Actuator Max Hot Position: Air mix actuator (RH) is operating so that air mix door position is at MAX HOT control
- AirMix RH Actuator Half Position: Air mix actuator (RH) is operating so that air mix door position is at middle position of MAX COLD control and MAX HOT control
|
| AMB_TEMP |
°C, °F |
Displays the ambient temperature detected by the ambient temperature sensor. |
| AMB_TEMP_INTERNAL |
°C, °F |
Displays the cabin temperature detected by the passenger compartment temperature sensor. |
| BLOWER_MOTOR_RLY |
OFF/ON |
- OFF: Blower relay is off
- ON: Blower relay is on
|
| CONSOLE_ILLMI_CTRL_STAT |
OFF/ON |
- OFF: Console illumination is not illuminated.
- ON: Console illumination is illuminated.
|
| ECT |
°C, °F |
Displays the engine coolant temperature detected by the ECT sensor. |
| EVA_TEMP |
°C, °F |
Displays the evaporator temperature detected by the evaporator temperature sensor. |
| FOOT_LAMP |
OFF/ON |
NOTE:
- It is displayed, however, if an accessory part is installed, it cannot be used.
|
| HEAT_CORE_TEMP |
°C, °F |
Heater core temperature is displayed. |
| ILLMI_STAT |
OFF/ON |
- OFF: Indirect illumination is not illuminated.
- ON: Indirect illumination is illuminated.
|
| INTAKE_ACTAT_MODE |
Stopped/Intake Actuator Fresh Position/Intake Actuator
Recirculation Position/Intake Actuator 25% Rec
Position/Intake Actuator 50% Rec Position/Intake Actuator
75% Rec Position |
- Stopped: Air intake actuator is stopped
- Intake Actuator Fresh Position: Air intake actuator is operating so that air intake door position is at FRESH 100%
- Intake Actuator Recirculation Position: Air intake actuator is operating so that air intake door position is at REC 100%
- Intake Actuator 25% Rec Position: Air intake actuator is operating so that air intake door position is at REC 25%/FRESH 75%
- Intake Actuator 50% Rec Position: Air intake actuator is operating so that air intake door position is at REC 50%/FRESH 50%
- Intake Actuator 75% Rec Position: Air intake actuator is operating so that air intake door position is at REC 75%/FRESH 25%
|
| LIFT_DOWN_SW |
Off/On |
- Off: Lift switch is not in down
- On: Lift switch is in down
|
| LIFT_UP_SW |
Off/On |
- Off: Lift switch is not in up
- On: Lift switch is in up
|
| MEMORY_SEAT_LIFT |
Stop/Moving Upward/Moving Downward |
- Stop: Driver-side lift motor is stopped and driver-side front seat height is not adjusted upward and downward
- Moving Upward: Driver-side lift motor adjusts driver-side front seat height upward
- Moving Downward: Driver-side lift motor adjusts driver-side front seat height downward
|
| MEMORY_SEAT_RECLINE |
Stop/Moving Forward/Moving Backward |
- Stop: Driver-side recliner motor is stopped and angle of driver-side front seat back is not adjusted forward and rearward
- Moving Forward: Driver-side recliner motor adjusts angle of driver-side front seat back forward
- Moving Backward: Driver-side recliner motor adjusts angle of driver-side front seat back rearward
|
| MEMORY_SEAT_SLIDE |
Stop/Moving Forward/Moving Backward |
- Stop: Driver-side slide motor is stopped and front and back positions of driver-side front seat are not adjusted forward and rearward
- Moving Forward: Driver-side slide motor adjusts front and back positions of driver-side front seat forward
- Moving Backward: Driver-side slide motor adjusts front and back positions of driver-side front seat rearward
|
| MEMORY_SEAT_TILT |
Stop/Moving Upward/Moving Downward |
- Stop: Driver-side tilt motor is stopped and height of driver-side front seat cushion front side is not adjusted upward and downward
- Moving Upward: Driver-side tilt motor adjusts height of driver-side front seat cushion front side upward
- Moving Downward: Driver-side tilt motor adjusts height of driver-side front seat cushion driver-side front side downward
|
| MODE_ACTAT_MODE |
Stopped/Mode Actuator Vent Position/Mode Actuator Bi-Level Position/Mode Actuator Heat Position/Mode Actuator Def-Heat Position/Mode Actuator Defroster Position |
- Stopped: Airflow mode actuator is stopped
- Mode Actuator Vent Position: Airflow mode actuator is operating so that mode door position is at VENT
- Mode Actuator Bi-Level Position: Airflow mode actuator is operating so that mode door position is at Bi-Level
- Mode Actuator Heat Position: Airflow mode actuator is operating so that mode door position is at HEAT
- Mode Actuator Def-Heat Position: Airflow mode actuator is operating so that mode door position is at DEF/HEAT
- Mode Actuator Defroster Position: Airflow mode actuator is operating so that mode door position is at DEFROSTER
|
| POWER_SEAT_MOTOR_VOLT |
V |
Displays the power supply voltage (BATT_PS) to the position memory control module |
| PTC_HEAT_OUT |
W |
Displays PTC heater output value |
| R_ SEAT_HEAT_DUTY_L |
% |
Displays rear seat warmer unit (LH) control duty value. |
| R_SEAT_HEAT_DUTY_L |
% |
Displays rear seat warmer unit (RH) control duty value. |
| R_SEAT_ HEAT_IND_L |
Off/Low/Mid/High |
- Off: Rear seat warmer switch (LH) is OFF
- Low: Rear seat warmer switch (LH) is Low
- Mid: Rear seat warmer switch (LH) is Mid
- High: Rear seat warmer switch (LH) is High
|
| R_SEAT_HEAT_IND_R |
Off/Low/Mid/High |
- Off: Rear seat warmer switch (RH) is OFF
- Low: Rear seat warmer switch (RH) is Low
- Mid: Rear seat warmer switch (RH) is Mid
- High: Rear seat warmer switch (RH) is High
|
| R_SEAT_HEAT_STAT_L |
Off/On |
- Off: Output from rear seat warmer unit (LH) is not fed back to rear seat warmer (LH)
- On: Output from rear seat warmer unit (LH) is fed back to rear seat warmer (LH)
|
| R_SEAT_HEAT_STAT_R |
Off/On |
- Off: Output from rear seat warmer unit (RH) is not fed back to rear seat warmer (RH)
- On: Output from rear seat warmer unit (RH) is fed back to rear seat warmer (RH)
|
| R_SEAT_HEAT_SW_IG |
IG OFF/IG ON |
- IG OFF: Dash-electrical supply unit detects that rear seat warmer switch IG1 power supply is off.
- IG ON: Dash-electrical supply unit detects that rear seat warmer switch IG1 power supply is on.
|
| R_SEAT_HEAT_SW_L |
Off/On |
- Off: Rear seat warmer switch (LH) is off
- On: Rear seat warmer switch (LH) is on
|
| R_SEAT_HEAT_SW_R |
Off/On |
- Off: Rear seat warmer switch (RH) is off
- On: Rear seat warmer switch (RH) is on
|
| R_SEAT_HEAT_SW_VOLT |
V |
Rear seat warmer switch supply voltage is displayed. |
| R_SEAT_HEAT_TEMP_L |
°C, °F |
Rear seat warmer unit (LH) thermistor temperature is displayed. |
| R_SEAT_HEAT_TEMP_R |
°C, °F |
Rear seat warmer unit (RH) thermistor temperature is displayed. |
| R_VENT_ACTAT_MODE |
Stopped/Rear Vent Actuator Vent Position/Rear Vent
Actuator Heat Position/Rear Vent Actuator Defroster
Position |
- Stopped: Rear vent actuator is stopped
- Rear Vent Actuator Vent Position: Rear vent actuator is operating so that rear vent door position is at VENT
- Rear Vent Actuator Heat Position: Rear vent actuator is operating so that rear vent door position is at HEAT
- Rear Vent Actuator Defroster Position: Rear vent actuator is operating so that rear vent door position is at DEFROSTER
|
| RECLINE_BACK_SW |
Off/On |
- Off: Recliner switch is not in backward
- On: Recliner switch is in backward
|
| RECLINE_FWD_SW |
Off/On |
- Off: Recliner switch is not in forward
- On: Recliner switch is in forward
|
| S_BELT_STAT |
Not Buckled/Buckled |
- Not Buckled: Driver-side front seat belt not fastened (Driver-side buckle switch on)
- Buckled: Driver-side front seat belt fastened (Driver-side buckle switch off)
|
| SEAT_HEAT_VOLT_F |
V |
Displays the power supply voltage (BATT_SH1, BATT_SH2) to the front seat warmer control unit. |
| SEAT_UNIT_VOLT |
V |
Displays the power supply voltage (IG1) to the position memory control module/front seat warmer control unit/front seat ventilation control unit. |
| SLIDE_BACK_SW |
Off/On |
- Off: Slide switch is not in backward
- On: Slide switch is in backward
|
| SLIDE_FWD_SW |
Off/On |
- Off: Slide switch is not in forward
- On: Slide switch is in forward
|
| SOLAR_SEN_L |
W/m 2 |
Displays the sunlight intensity on the left side of the windshield detected by the solar radiation sensor. |
| SOLAR_SEN_R |
W/m 2 |
Displays the sunlight intensity on the right side of the windshield detected by the solar radiation sensor. |
| STOP_START_STAT |
Stop Available/Stop Not Available |
- Stop Available: i-stop control enabled
- Stop Not Available: i-stop control disabled
|
| TELESCO_STR_BACK_SW |
Off/On |
- Off: Tilt/telescoping switch is not in backward
- On: Tilt/telescoping switch is in backward
|
| TELESCO_STR_FWD_SW |
Off/On |
- Off: Tilt/telescoping switch is not in forward
- On: Tilt/telescoping switch is in forward
|
| TELESCO_STR_MOTOR_STAT |
Stop/Moving Forward/Moving Backward |
Displays telescoping motor status. |
| TILT_DOWN_SW |
Off/On |
- Off: Tilt switch is not in down
- On: Tilt switch is in down
|
| TILT_STR_DOWN_SW |
Off/On |
- Off: Tilt/telescoping switch is not in down
- On: Tilt/telescoping switch is in down
|
| TILT_STR_MOTOR_STAT |
Stop/Moving Forward/Moving Backward |
Displays tilt motor status. |
| TILT_STR_UP_SW |
Off/On |
- Off: Tilt/telescoping switch is not in up
- On: Tilt/telescoping switch is in up
|
| TILT_TELESCO MOTOR_V |
V |
Displays the power supply voltage (SSR_POWER) to the telescoping motor/tilt motor. |
| TILT_UP_SW |
Off/On |
- Off: Tilt switch is not in up
- On: Tilt switch is in up
|
| VPWR |
V |
Displays the power supply voltage to the dash-electrical supply unit. |
| WALK-IN_SW_L |
Off/On |
- Off: Walk-in switch (LH) is off
- On: Walk-in switch (LH) is on
|
| WALK-IN_SW_R |
Off/On |
- Off: Walk-in switch (RH) is off
- On: Walk-in switch (RH) is on
|