DTC B1B96-23: Slide Switch (Front) Circuit Malfunction
B1B96:23 (DASH_ESU) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Slide switch (front) circuit malfunction |
| Detection condition |
- The dash-electrical supply unit detects that slide switch (front) circuit is stuck on.
|
| Fail-safe |
|
| Possible cause |
- Malfunction in wiring harness (including connector/terminal) between driver-side power seat switch and position memory control module (slide switch (front) circuit) (See CIRCUIT INSPECTION
.) (See CONNECTOR INSPECTION
.)
- Driver-side power seat switch malfunction (Refer to [POWER SEAT SWITCH INSPECTION
]
).
- Position memory control module malfunction (Refer to [POSITION MEMORY CONTROL MODULE REMOVAL/INSTALLATION
]
).
- Dash-electrical supply unit malfunction (Refer to [DASH-ELECTRICAL SUPPLY UNIT REMOVAL/INSTALLATION
]
).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
Position memory control module |
| 2 |
Driver-side power seat switch |