Connected service is not contracted
- Perform the configuration. (Refer to [
CONFIGURATION] in the appropriate troubleshooting information
).NOTE:
- DTC U2050:55 is displayed if the activating remote control by smart phone is not implemented. If only DTC U2050:55 is displayed, continue to perform the procedure as indicated as this does not indicate an improper procedure.
- Clear the DTC. (Refer to [CLEARING DTC ] in the appropriate troubleshooting information )
- Cancel connected vehicle maintenance mode. (See SERVICE CAUTIONS FOR VEHICLES WITH TELEMATICS COMMUNICATION SYSTEM .)
- Perform the activating remote control by smart phone. (See ACTIVATING REMOTE CONTROL BY SMART PHONE ).
- Perform the telematics communication unit initial setting. (See TELEMATICS COMMUNICATION UNIT INITIAL SETTING ).