Connected service is contracted

Perform the configuration. (Refer to [ CONFIGURATION] in the appropriate troubleshooting information ).
NOTE:
- DTC U2050:55 is displayed if the activating remote control by smart phone is not implemented. If only DTC U2050:55 is displayed, continue to perform the procedure as indicated as this does not indicate an improper procedure.
Clear the DTC. (Refer to [CLEARING DTC ] in the appropriate troubleshooting information )
Cancel connected vehicle maintenance mode. (See SERVICE CAUTIONS FOR VEHICLES WITH TELEMATICS COMMUNICATION SYSTEM .)
Perform the activating remote control by smart phone. (See ACTIVATING REMOTE CONTROL BY SMART PHONE ).
Perform the telematics communication unit initial setting. (See TELEMATICS COMMUNICATION UNIT INITIAL SETTING ).
Switch the ignition OFF/switch the main power OFF and wait for 5 min or more.
NOTE:
- It takes approx. 5 min to complete the communication processing for the telematics communication system.
Switch the ignition ON (engine off or on)/switch the main power ON (READY off or on) and wait for 1 min or more.
NOTE:
- It takes approx. 1 min to complete the communication processing for the telematics communication system.
Launch the diagnostic assist function. (Refer to the [DIAGNOSTIC ASSIST FUNCTION [CMU] ] in the appropriate troubleshooting information ).
Select [Service Information] on the diagnostic assist function initial screen.
Select [TCU Linked Information] on the [Service Information] screen.

Verify that the remote service flag in the [Remote Service Flag Information] indicates [1] as shown in the figure.

Courtesy of MAZDA MOTORS CORP.

COMPONENT OPERATIONS

Component No.	Refer to
1	Remote service flag