Remove Dashboard (L.H.D).: Notes

Fig 1: Dashboard Components Location With Torque Specification (L.H.D.)

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATION

Step	Part name	Applicable condition
1	Connector	With driver monitoring system	-	-
2	Wiring harness clip (See Wiring harness clip removal note ).	With driver monitoring system	-	-
3	Connector	With rear view monitor (vehicle width extension lines)	-	-
4	Connector	With rear view monitor (guide line)	-	-
5	Connector	-	-	-
6	Wiring harness clip (See Wiring harness clip removal note ).	-	-	-
7	Bolt	-	-	26 N.m {2.65 kgf.m, 19.2 ft.lbf}
8	Nut	-	-	26 N.m {2.65 kgf.m, 19.2 ft.lbf}
9	Dashboard bracket	-	-	-
10	Bolt	-	-	7.5 N.m {75 kgf.cm, 65 in.lbf}
11	Bolt	-	Replacement part	10 N.m {102 kgf.cm, 89 in.lbf}
12	Bolt	-	-	19 N.m {1.95 kgf.m, 14.1 ft.lbf}
13	Dashboard (See Dashboard Removal Note ).	-	-	-