Inspect Indicator Unit: Notes
NOTE:
- Perform the procedure with the sensor cover removed. (See SENSOR COVER REMOVAL/INSTALLATION )
- Connect the negative lead-acid battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION )
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.
- If the system does not operate normally even though the parts or related wiring harnesses do not have any malfunction replace the indicator unit. (See INDICATOR UNIT REMOVAL/INSTALLATION [L.H.D.] )
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s) and related wiring harnesses.