Remove Driver Side Strut Tower Bar: Notes

1. Remove using the procedure shown in the figure below.
   • the figure below shows the left side (same as right side).

Fig 1: Driver Side Strut Tower Bar, Wiring Harness Clip, Bolts And Nuts With Torque Specification

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATION

Step	Part name
1	Wiring harness clip (See Wiring harness clip removal note )	-
2	Bolt	35 N.m {3.55 kgf.m, 25.8 ft.lb}
3	Nut	35 N.m {3.55 kgf.m, 25.8 ft.lb}
4	Strut tower bar	-