Repeatability Verification Procedure
WARNING: This page is about a different variant/trim than selected.
- Set the remaining fuel quantity in the fuel tank between 30-85 %.
- Verify that OBD-II information (such as freeze frame data) has been obtained and recorded.
- Clear the DTC from the PCM memory using the M-MDS. (see CLEARING DTC .)
- Start the engine and switch the ignition off after 5 s have elapsed.
- Leave the vehicle for 6 hours or more.
- Start the engine and leave it idling for 2 min.
- Drive the vehicle for 30 min at a speed of 50 km/h {31 mph} or more (to increase temperature in fuel tank and generate evaporative gas).NOTE:
- If driving the vehicle for 30 min at a speed of 50 km/h {31 mph} or more is not feasible, the vehicle can be driven for a continuous 15 min or more with the engine coolant temperature at 80°C {176°F} or more.
- Stop the engine.
- Leave the vehicle for 1 hours or more.