LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (On-Board Diagnostic - Engine Control (VIN Y) (3 Of 6)) >> DTC P0455-00: Evaporative Gas Leakage (Leakage Amount: Large) >> Repeatability Verification Procedure

Repeatability Verification Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Set the remaining fuel quantity in the fuel tank between 30-85 %.
  2. Start the engine and switch the ignition off after 5 s have elapsed.
  3. Leave the vehicle for 6 hours or more.
  4. Start the engine and leave it idling for 2 min.
  5. Drive the vehicle for 30 min at a speed of 68 km/h {42 mph} or more (to increase temperature in fuel tank and generate evaporative gas).
    NOTE:
    • If driving the vehicle for 30 min at a speed of 68 km/h {42 mph} or more is not feasible, the vehicle can be driven for a continuous 15 min or more with the engine coolant temperature at 80°C {176°F} or more.
scientia non olet · About LEMON Manuals