DTC P0454-00: Fuel Tank Pressure Sensor Intermittent Malfunction
WARNING: This page is about a different variant/trim than selected.
P0454-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Fuel tank pressure sensor intermittent malfunction |
| Detection condition |
- Any one of the following conditions is met:
- The difference between the currently detected fuel tank pressure sensor input voltage and the previously detected input voltage is large.
- The input voltage of the fuel tank pressure sensor remains low or high.
|
| Fail-safe |
|
| Possible cause |
- Malfunction in wiring harness (including connector/terminal) between PCM and fuel tank pressure sensor (see CIRCUIT INSPECTION
.) (see CLEARING DTC
.)
- Fuel tank pressure sensor malfunction (Refer to FUEL TANK PRESSURE SENSOR INSPECTION (VIN Y)
in the service information.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOER self test. (See DTC INSPECTION
.)
|
| System wiring diagram |
|