DTC P0365-00: Exhaust CMP Sensor System: Circuit Malfunction
WARNING: This page is about a different variant/trim than selected.
P0365-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
Exhaust CMP sensor system: Circuit malfunction |
| Detection condition |
- The exhaust camshaft position sensor input signal pattern received during specified rotation of the crankshaft is incorrect.
- Cylinder identification is not completed during specified rotation of the crankshaft.
|
| Fail-safe |
- Stops fuel injection.
- Stops ignition.
|
| Possible cause |
- Malfunction in wiring harness (including connector/terminal) between sub relay and exhaust CMP sensor (see CIRCUIT INSPECTION
.) (see CLEARING DTC
.)
- Malfunction in wiring harness (including connector/terminal) between exhaust CMP sensor and PCM (see CIRCUIT INSPECTION
.) (see CLEARING DTC
.)
- Exhaust CMP sensor malfunction (Refer to CAMSHAFT POSITION (CMP) SENSOR INSPECTION (VIN Y)
in the service information.)
- Dirt on exhaust CKP sensor detection area
- Exhaust CMP sensor pulse wheel malfunction
- Loose timing chain or improper valve timing (Refer to TIMING CHAIN REMOVAL/INSTALLATION (VIN Y)
in the service information.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.)
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOER self test. (See DTC INSPECTION
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
Battery |
| 2 |
Sub relay |
| 3 |
Exhaust CMP sensor |
| 4 |
PCM |