Details On DTCs

WARNING: This page is about a different variant/trim than selected.

P0234-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location	Dynamic pressure turbo overboost condition
Detection condition	Determination conditions	As the result of comparing the actual air charging pressure with the limited pressure, the actual air charging pressure exceeds the limited air charging pressure.
	Preconditions	2 s have elapsed with all of the following conditions met during boost control feedback. Engine speed: 500 rpm or more The following DTCs are not detected: Boost pressure sensor: P0237:00 and P0238:00 BARO sensor: P2228:00 and P2229:00
	Drive cycle	1
	Self test type	CMDTC self test
	Sensor used	MAP sensor
Fail-safe	Limits intake air amount. (Only period of time when PCM determines that air is excessively boosted)
Vehicle status when DTCs are output	Not applicable
Possible cause	Erratic signal to PCM MAP sensor signal malfunction Input signal part connector or terminals malfunction Input signal part related circuit malfunction Vacuum piping or positive pressure piping of wastegate valve actuator malfunction Air bypass valve malfunction Wastegate valve position sensor malfunction Wastegate valve actuator malfunction Dynamic pressure turbo malfunction PCM malfunction