LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (On-Board Diagnostic - Engine Control (VIN Y) (2 Of 6)) >> DTC P0116-00: ECT Sensor No. 1 System: Function Malfunction >> Function Inspection Using M-MDS

Function Inspection Using M-MDS

WARNING: This page is about a different variant/trim than selected.
P0116-00: (PCM - VIN Y) FUNCTION INSPECTION USING M-MDS

Step Inspection Results Action
1 PURPOSE: RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION 
  • Record the freeze frame data/snapshot data.
    NOTE:
    • Recording can be facilitated using the screen capture function of the PC.
 - Go to the next step.
2 PURPOSE: VERIFY CONNECTOR CONNECTIONS 
  • Start the engine.
  • Access the PCM PID [ECT] using the M-MDS.
  • Does the PID value fluctuate when the following connectors are shaken?
    • ECT sensor No. 1
    • PCM
 Yes Repair or replace the applicable connector parts.
Go to Troubleshooting Diagnostic Procedure to perform the repair completion verification 1.
No Go to the next step.
3 PURPOSE: VERIFY ECT SENSOR No. 1 INPUT SIGNAL 
  • Access the PCM PID [ECT] using the M-MDS.
  • Is the monitoring value normal?
 Yes Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 3.
No Go to Troubleshooting Diagnostic Procedure to perform the procedure from Step 1.
scientia non olet · About LEMON Manuals