LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (On-Board Diagnostic - Engine Control (VIN Y) (2 Of 6)) >> DTC P0116-00: ECT Sensor No. 1 System: Function Malfunction >> Details On DTCs

Details On DTCs

WARNING: This page is about a different variant/trim than selected.
P0116-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE

System malfunction location ECT sensor No. 1 system: Function malfunction
Detection condition Determination conditions
  • The engine coolant temperature detected by the ECT sensor No. 1 does not increase to the standard or more within the specified period of time after the engine is started.
Preconditions
  • Before starting the engine, leave the vehicle with the engine turned off for 6 hours or more.
  • The following DTCs are not detected:
    • ECT sensor No. 1: P0117-00: and P0118-00:
Malfunction determination period
  • Not applicable
Drive cycle
  • 1
Self test type
  • CMDTC self test
Sensor used
  • ECT sensor No. 1
Fail-safe
  • Not applicable
Vehicle status when DTCs are output
  • Not applicable
Possible cause
  • ECT sensor No. 1 connector or terminal malfunction
  • PCM connector or terminal malfunction
  • ECT sensor No. 1 incorrect installation
  • ECT sensor No. 1 malfunction
  • Poor assembly of engine coolant hose (engine coolant passage malfunction)
  • Poor engine coolant, leakage, or freezing
  • Use of unspecified engine coolant
  • Thermostat malfunction
  • PCM malfunction