DTC P0108-00: Map Sensor System: High Input
WARNING: This page is about a different variant/trim than selected.
P0108-00: (PCM - VIN Y) DETECTION CONDITION AND POSSIBLE CAUSE
| System malfunction location |
MAP sensor system: High input |
| Detection condition |
- The specified period of time has elapsed while the MAP sensor voltage exceeds the standard.
|
| Fail-safe |
- Estimates MAP using MAF sensor and engine speed.
- Restricts the upper limit of the engine speed.
- Inhibits the evaporative purge control.
|
| Possible cause |
- Malfunction in wiring harness (including connector/terminal) between MAP sensor and PCM (see CIRCUIT INSPECTION
.) (see CONNECTOR INSPECTION
.)
- MAP sensor malfunction (Refer to MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION (VIN Y)
in service information.)
- PCM malfunction (Refer to applicable PCM REMOVAL/INSTALLATION (VIN Y)
in the service information.
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (see CLEARING DTC
.)
- Perform the KOEO or KOER self test. (See DTC INSPECTION
.)
|
 Courtesy of MAZDA MOTORS CORP.
|
| 1 |
PCM |
| 2 |
MAP sensor |